Indesit BV 40 L/CS F Istruzioni per l'uso Pagina 16

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 15
GB
16
Important: A pressure regulator, in compliance with
the standards in force, must be inserted when
connecting to a liquid gas supply (in a cylinder).
Adaptation to a different type of gas
If the hob is to be converted for use with a type of
gas other than that for which it was set in the factory
(indicated on the label to be found on the hob), the
burner nozzles should be replaced as follows:
Remove the pan supports and the burners.
Unscrew the nozzles “A” (fig.6) using a 7 mm
socket wrench and replace them with the ones
which have a diameter suitable for the type of gas
to be used, according to the table 1 "burners and
nozzles specifications).
• On completing the operation, replace the old rating
label with the one showing the new type of gas; the
sticker is available from our Service Centres.
Adjusting the low flame
Put the tap to the low flame position;
Remove the tap knob and turn the adjusting screw,
situated inside of the tap stem (fig.7), using a
screwdriver (loosening the screw increases the
height of the flame, tightening decreases it).
note: the adjusting screw must be fully screwed down
for liquid gas.
Having obtained the low flame setting required and
with the burner lit, abruptly change the position of
the knob several times from minimum to maximum
and vice versa and check that the flame does not
go out.
DATA PLATE
Electrical
connections
voltage of 230V ~ 50Hz (see data
plate )
This appliance conforms to the
following European Economic
Community directives:
-73/23/EEC dated 19/02/73 (Low
Voltage) and subsequent
amendments
- 89/336/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 90/336/EEC dated 29/06/90 (Gas)
and subsequent amendments.
- 2002/96/EC
Fig.7
A
Fig.5
Fig.6
Vedere la pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

Commenti su questo manuale

Nessun commento